74th OREGON LEGISLATIVE ASSEMBLY--2007 Regular Session
 
CCA to B-Eng. HB 2112
 
LC 765/HB 2112-B11
 
               CONFERENCE COMMITTEE AMENDMENTS TO
                   B-ENGROSSED HOUSE BILL 2112
 
                             June 20
 
 
 
 
                         Amended Summary
  Prohibits person licensed or required to be licensed by
Construction Contractors Board from installing barrier-type
insulation and finish system on new   { - residential
dwelling - }   { +  building + } or, except as necessary to
repair or replace previously installed system, on existing
 { - residential dwelling - }  { +  building + }. Defines terms.
 
Speaker Merkley:
  Your Conference Committee to whom was referred B-engrossed
House Bill 2112, having had the same under consideration,
respectfully reports it back with the recommendation that the
House concur in the Senate amendments dated June 4 and that the
bill be amended as follows and repassed.
 
  Delete lines 5 through 19 of the printed B-engrossed bill and
insert:
  '  { +  SECTION 2. + }  { + (1) As used in this section,
'barrier-type exterior insulation and finish system' means a foam
insulation board inner layer, a polymer and cement base coat
middle layer reinforced with glass fiber mesh and a textured
finish coat exterior layer, in which:
  ' (a) The layers are bonded to the outside face of an exterior
wall;
  ' (b) The middle or exterior layer, but not the inner layer,
provides a water resistant barrier for the exterior of the
building envelope;
  ' (c) The layers do not provide a means of drainage for water
that accumulates behind the exterior surface; and
  ' (d) The layers insulate the building.
  ' (2) A person licensed or required to be licensed under this
chapter may not install a barrier-type exterior insulation and
finish system on:
  ' (a) A new building; or
  ' (b) An existing building, except as necessary to repair or
replace a previously installed barrier-type exterior insulation
and finish system.
  ' (3) Subsection (2) of this section does not apply to the
application of a barrier-type exterior insulation and finish
system:
  ' (a) As an architectural feature that is not intended to
protect an interior space of the building; or
  ' (b) To a concrete wall or a concrete masonry unit block
wall. + } ' .
 
                         /sPaul Holvey
                           Representative
 
                         /sFred Girod
                           Representative
 
                         /sMike Schaufler
                           Representative
 
                         /sLarry George
                           Senator
 
                         /sRick Metsger
                           Senator
 
                         /sJackie Winters
                           Senator
                         ----------